OEM wheel and tire fitment specs for the 1999 Volkswagen Jetta, including bolt pattern (PCD), center bore diameter, thread size, rim diameter, rim width, wheel offset, and backspacing.
1999 Volkswagen Jetta Fitment Specs
Baseline mounting dimensions used for interchange decisions.
Multiple OEM configurations exist for this vehicle. Fitment can vary by trim, brakes, and factory wheel package – confirm your exact setup before buying.
Wheels That Interchange With a 1999 Volkswagen Jetta
Results are evaluated from bolt pattern, center bore direction, OEM width/offset envelope, and lug hardware – not bolt pattern alone.
Use lug nuts compatible with your vehicle's studs. Geometry within known OEM envelope (approx. outer change -4.68 mm, inner change -1.67 mm vs mid OEM).
Use lug nuts compatible with your vehicle's studs. Geometry within known OEM envelope (approx. outer change -3.68 mm, inner change -2.68 mm vs mid OEM).
Use lug nuts compatible with your vehicle's studs. Geometry within known OEM envelope (approx. outer change -3.68 mm, inner change -2.68 mm vs mid OEM).
Use lug nuts compatible with your vehicle's studs. Geometry within known OEM envelope (approx. outer change -4.68 mm, inner change -1.67 mm vs mid OEM).
Use lug nuts compatible with your vehicle's studs. Geometry within known OEM envelope (approx. outer change -4.68 mm, inner change -1.67 mm vs mid OEM).
Use lug nuts compatible with your vehicle's studs. Geometry within known OEM envelope (approx. outer change -4.68 mm, inner change -1.67 mm vs mid OEM).
A normal wheel spacer does not change bolt pattern. Hub rings cannot enlarge a wheel bore that is smaller than the hub. Brake clearance and tire package fitment still require vehicle-specific checks when not confirmed in the dataset.
1999 Volkswagen Jetta Wheel Fitment
Bolt Pattern
4x100, 5x100
Center Bore
57.1 mm
Thread Size
M12 x 1.5
Rim Diameter
15"
Rim Width
6.0"
Wheel Offset
38 mm
Use the calculator below to compare wheels from another vehicle against your 1999 Volkswagen Jetta, or check compatible donor vehicles that share the same bolt pattern and center bore.
Fitment Basics
Always confirm center bore matches your hub, or use hub-centric rings to take up the gap.
Check offset carefully – wheels that stick out too far can rub on fenders or suspension components.
Verify thread size and lug type before buying replacement bolts or lug nuts.
When in doubt, use the calculator below to compare exact specs side by side.